Soldering electronics can be really frustrating if you don't have the right materials, tools, and techniques. After teaching 100+ folks how to solder for electronics in my role at the Boulder Public Library Makerspaces, I created a couple of larger-than-life tools for demonstrating concepts like positioning the soldering iron tip/solder and understanding what too much or too little solder on a joint looks like. Those tools plus a bonus link out to my favorite soldering resource from Adafruit are all in the Canvas below:

"Soldering iron tip" (wooden towel painted silver, and chisel-shaped at one end to replicate a chisel-tipped soldering iron)

"Soldering iron tip" (wooden towel painted silver, and chisel-shaped at one end to replicate a chisel-tipped soldering iron)

Beginners often add too much, or too little solder. This demo illustrates good & bad soldering joints using aluminum foil.

photo from Adafruit soldering guide

"Through holes" and "pins" (wooden dowels painted silver, placed inside of holes cut in a little box)

How I use these: Demo with the large scale teaching tools first to illustrate points like correct placement and angle of the soldering iron, where the solder should be placed – then demo with the real tools under a document camera so all can see a little easier

Print-outs of real-life soldering examples and tips create a useful reference point. Soldering demos happen fast, but these pictures "pause" at critical points that learners can revisit whenever needed.

"Solder" (foil wrapped around armature wire)

My favorite soldering guide that I like to reference & share!

Side note – soldering happens at a small scale, which is hard to show to folks if you have a big group. In part, that's why I use jumbo sized demo tools. But a good document camera goes a long way as well, and I often pair a "real" soldering demo on the document camera with a pretend demo using the tools I shared above.

View from the document camera in the STUDIO 24 Makerspace.